Glow Worm 3. 0- 4. DInstructions for Use. Introduction. Please read these instructions and follow them carefully for thesafe and economical use of your boiler. The Economy Plus “F” Range are boilers designed to providecentral heating and indirect domestic hot water from a fullypumped system with a fully indirect cylinder.
Glow-worm Offer A Variety Of Domestic Boiler Types For The. Get a boiler installation quote from your local Glow-worm installer to make sure you're in the best. Glow Worm 30-40-50f boiler instructions - Free download as PDF File (.pdf), Text File (.txt). Hand the Instructions for Use to the user for their retention. To be left with the user Instructions for Use. be left with the user. Please read these instructions and follow them carefully. www.glow-worm.co.uk 7 Boiler. Www.glow-worm.co.uk Instrctions for Use. 8.3 User Controls. The Ultracom 2 boiler is an appliance. Glow-worm, Nottingham Road, Belper, Derbyshire. DE56 1JT www.glow-worm.co.uk To be left with the user Instructions for. is conditional upon the boiler having been. Thank you for installing a new Glow-worm appliance in. Instructions for Use Installation and Servicing. C 2402 The instructions consist of three parts, User. Glow-worm Boiler Manuals & Literature Downloads. All of Glow-worm's energy and heating product literature. Operation instructions; Installation Instructions.
Glow-worm, Nottingham Road. www.glow-worm.co.uk To be left with the user Instructions for Use Installation and Servicing 24cxi 30cxi 38cxi G.C. No. 47-047-23 G.C.
Important Notice. This boiler is for use only on natural gas G2. Gas Safety (Installation and Use) Regulations. In your interest and that of gas safety it is the Law that ALL gasappliances are installed by a competent person in accordancewith the current issue of the above regulations. Gas Leak or Fault. If a gas leak or fault exists or is suspected, the BOILER MUSTBE TURNED OFF, including the electrical supply and MUSTNOT BE USED UNTIL THE FAULT HAS BEEN PUT RIGHT.
Advice/help should be obtained from your installation/servicingcompany or the local gas undertaking. Maintenance/Servicing. To ensure the continued efficient and safe operation of theboiler it is recommended that it is checked and serviced asnecessary at regular intervals. The frequency of servicing willdepend upon the particular installation conditions and usage,but in general once a year should be enough. If this appliance is installed in a rented property there is a dutyof care imposed on the owner of the property by the currentissue of the Gas Safety (Installation and Use) Regulations,Section 3. It is the Law that any servicing must be carried out by acompetent person. To obtain service, please call your installer or Heatcall (Glow- worm’s own service organisation) using the telephone numbergiven on the case tray.
Please be advised that the ‘Benchmark’ logbook should becompleted by the installation engineer on completion ofcommissioning and servicing. All CORGI Registered Installers carry a CORGI ID card, andhave a registration number.
Both should be recorded in yourboiler Logbook. You can check your installer is CORGI registeredby calling CORGI direct on : - 0. Boiler Clearances. If fixtures are positioned close to the boiler space must be leftas shown in diagram 3. Enough space must also be left infront of the boiler to allow for servicing. Boilers Installed in a Compartment or.
Cupboard. If the boiler is installed in a cupboard or compartment do notobstruct any ventilation openings. Do not use the cupboard or compartment for storage. Regularly make sure that the air vent openings are clear ofobstructions. Cleaning. WARNING. This appliance contains metal parts (components)and care should be taken when handling and cleaning, withparticular regard to edges. Clean the casing occasionally by wiping it over with a dampsoapy cloth or dry polishing duster. Do not use an abrasive cleaner.
Boiler Electrical Supply. WARNING. The boiler must be earthed. The boiler must only be connected to a 2. V~5. 0Hz supply,protected by a 3.
A fuse. All wiring must be in accordance with the current issue of. BS7. 67. 1. The colours of three core flexible cable are: Brown - live, blue - neutral, green and yellow - earth. As the markings on your plug may not correspond with thesecolours, continue as follows,The wire coloured blue must be connected to the terminalmarked “N” or “Black”. The wire coloured brown must be connected to the terminalmarked “L” or “Red”. The wire coloured green and yellow must be connected to theplug terminal marked “E” or “Green” or the earth symbol "" . Electrical Supply Failure.
Failure of the electrical supply will cause the burner to go out. Should this happen, operation of the appliance will normallyresume after the electrical supply is restored.
If the burner does not relight after an electrical supply failure theoverheat device may need resetting, refer to diagram 1, removethe controls tray and press the reset button. If the cutoff occurs again, turn the appliance off and contact yourinstallation/servicing company.